42
7. Operation
7.4 Changing the front / rear grinding wheels
Close the safety doors.
Change to settings via the main menu “F5 Set-
tings” (3-8/15). Move the grinding wheels into
dressing position by pressing “Dressing Position”
(7-24/1) on the touch panel
Open the safety doors.
ATTENTION
Turn the “Setup Mode” key switch (3-7/5)
to position “1”.
Use SW6 Allen wrench to loosen and remove the
screw at the center of the grinding wheel (7-25/1)
by turning it counter-clockwise.
Remove the front or rear grinding wheel and also
the connection flange (7-26/1) if necessary and
mount the new grinding wheel in the reverse
order.
If the grinding wheel is half-worn, mount the
connection flange (7-26/1) with an M8x40 screw.
NOTICE
Two connection flanges with corresponding
screws are included in the accessories.
Figure 7-24
Settings
Figure 7-25
Change grinding wheels
1
Figure 7-26
Connection flange
1
1
