40
7. Operation
There is a risk of clothing and hair getting entangled. There is a risk of
hands being crushed. This can result in serious injury.
To prevent dust formation, always have the coolant tap on while
dressing and direct the coolant hose at the grinding wheels.
Never dress with mounted knives.
This can result in serious cut injuries.
CAUTION
7.3 Dressing the front / rear grinding wheel
If the front grinding wheel is running out of true
or is loaded, it must be dressed.
Close the safety doors.
Change to settings via the main menu “F5 Set-
tings” (3-8/15). Press “Dressing Position” (7-21/1)
on the touch panel to move the grinding wheels
into dressing position.
ATTENTION
Turn the “Setup Mode” key switch (3-7/5)
to position “1”.
Open the safety doors.
Switch on the front grinding wheel. To do so,
press “Grinding wheel front On / Off” (7-21/2) on
the touch panel.
Insert the deburring lever (7-22/1) as far as it will
go into the relevant bushing. Move the dressing
diamond (7-22/2) with the deburring lever evenly
over the grinding wheel, which is switched on.
The dressing diamond is fed by rotating the feed
nut (7-22/3) in clockwise direction.
Figure 7-22
Dress front grinding wheel
Figure 7-21
Settings
1
2
3
1
3
2
