KMC Controls BAC-4000 series, Installation, Operation, And Application Manual

Page: 38 / 128

Procedure Steps Display
4
Change the override
setpoint
Entering an override setpoint can only take
place if the AppStat is in the unoccupied mode.
1.
Push the button under the unoccupied icon
.
Note: If a user password has previously been
entered or if the AppStat has not been set up
with a user password, entering a password is
not required.
2.
Press either the or button to change the
first digit of the password.
3.
Press the Enter button to select the next
digit. Repeat for all four digits.
4.
Press either the or button to turn the
override on or off.
Override Off—The controller uses the
unoccupied setpoint as the active setpoint.
Override On—the controller changes to the
occupied setpoint which can then be
temporarily changed.
5.
Press the Enter button to save the setting.
Note:
When the system is in the unoccupied
mode, changing the active setpoint will
automatically place the system in the
override mode.
F
°
65
AUTO AUTO
Enter Cncl
LOCAL OVRD: ON
OFF
5
Change the display
units To temporarily change the display units to
either Celsius or Fahrenheit, press and hold the
middle button under the display until the units
change.
F
°
70
AUTO AUTO
° 21
c
.0
AUTO AUTO
Set the operating modes (continued)
Section 3: User functions KMC Controls, Inc.
38 Revision G