23
CS.ECO-TFT.IST-1-EN / Rev 1.0
ENGLISH
Switch-off cycle
The appliance switches off if you press button 4 (ON/OFF) during normal operation. The display will show
“FINAL CLEANING”
. The pellet loading
stops and the flue gas extractor speed increases to maximum and then switches off after the cooling of the appliance, displaying
“OFF”
.
If button 4 (ON/OFF) is pressed during the ignition cycle, the appliance switches to
“WAITING OFF
” and the appliance will be turned off only at the end
of the entire cycle; if, however, button 4 (ON/OFF) is pressed by mistake during this phase, you only need to press it again to delete
“WAITING OFF”
:
the appliance will return to normal operation at the end of the entire ignition cycle.
Modifying the working power and the temperatures of the room, boiler water, water heater or puffer
–
TFT Display
-
WORKING POWER
To modify the maximum working power, simply select “
SET
POWER
”
(Fig. 1)
then use the
+
and
–
buttons to changethe value
(Fig. 2)
.
After setting the desired value, confirm by
pressing the “back” arrow.
-
ROOM TEMPERATURE
In plant types 1, 2, 3 and 5, to modify the room temperature simply select the “SET ROOM”
(Fig. 3)
then use the
+
and
–
buttons to change the value
(Fig. 4)
.
After setting the
desired value, confirm by pressing the “back” arrow.
The room temperature setting and thus the “
SET
ROOM
” can be accessed only with the room sensor active (Sub
-menu 5.5
–
ROOM SENSOR = ON).
During the work phase the appliance enters
“Economy mode operation”
when the relevant temperature value is reached; the heating circulator pump
is therefore deactivated. The appliance switches off with a delay set to Pr44.
3
4
1
2
