29
CS.ECO-TFT.IST-1-EN / Rev 1.0
ENGLISH
To ensure correct operation, it is necessary to remove the sawdust deposited on the bottom of the tank
(Figure 10)
at least once every 30 days.
The
pellet tank must be emptied at the end of every season.
For improved reliability and efficiency, it is important to clean the pellet level sensor inside the tank, using a soft-bristle brush.
Cleaning the ceramic glass
Always clean the glass when the appliance is off and has cooled down completely. Use a damp cloth or a detergent specifically formulated for ceramic
glass. Do not use abrasive sponges. Do not clean the glass if still warm; changes in temperature can lead to breakage.
Cleaning the flue
The flue must be cleaned at least once a year, at the beginning of winter, and nonetheless whenever necessary.
This operation should be carried out
by an Authorised Technical Assistance Centre or by a certified chimney sweep.
It is important to check for any obstructions in the flue before switching the appliance on following long periods of inactivity.
If the flue is not cleaned, the operation of the appliance and its components may be compromised.
The cleaning frequency of the appliance and flue depends on the quality of the pellets used.
USE TOP-QUALITY PELLETS FOR OPTIMAL RESULTS.
Maintenance
Timely and systematic maintenance is essential for guaranteeing correct operation, optimal heat performance and durability of the device. Therefore,
qualified staff should check the appliance at least once a year at the beginning of the season.
You must periodically check the seals because the latter guarantee the air- and water-tightness of the appliance and its good functioning; if they are
worn or damaged you need to replace them immediately by contacting a
Klover Authorised Technical Assistance Centre.
For proper operation, the appliance must undergo routine maintenance performed by a Klover
Authorised Technical Assistance Centre
at
least once a year.
WIRING DIAGRAMS AND PARAMETER TABLES
The appliance’s wiring diagrams and parameters can be viewed by scanning the following QR Code with your smartphone.
Wiring diagram
Parameter tables
https://docs.klover.it/it/guide/help/cs-sche-l023-8_p-1
https://docs.klover.it/it/guide/help/cs-ecos-par-1
10
