DIVA SLIM AIR PELLET STOVE
29
EN - Rev. 1.0
- MAC ADDRESS and REGISTRATION CODE, which appear on the label affixed near the “Support panel”
(see
“Components of the appliance”)
.
12.
At this point, the appliance will be added and can be managed through the Web app from any device (PC / tablet /
smartphone) connected to the Internet.
It can be accessed from the address
or via the “My KLOVER” app, which can be
downloaded from various stores (Apple, Android, etc).
START-UP
Initial start-up
Perform the following operations:
-
Connect the appliance to the electrical system by using the provided cable;
-
Set the “power ON/OFF switch” on the rear side of the appliance to “
׀
” (on);
-
Fill the pellet tank; for the initial start-up, to avoid wasting the time required to fill the entire auger channel (this
should be done whenever the appliance runs out of pellets), we recommend following the instructions of “MENU
06 – INITIAL LOAD”;
-
Switch the appliance on by pressing the “ON/OFF” button located on remote control (button 3) or on the support
panel (button 1). See the instructions below. Warning: before switching on the appliance, make sure the brazier
is clean and that there are no pellets inside it; otherwise, empty and/or clean it.
We recommend that you use high quality pellets so as not to impair the operation of the appliance. Damage
caused by poor-quality pellets shall not be covered by the warranty.
Do not pour pellets manually into the brazier.
Ignition cycle
Prolonged pressing of button 3 (On/Off) on the remote control or of button 1 (On/Off) on the support panel allows for
switching the appliance on.
The ignition cycle can last 20/25 minutes max. and is divided into five steps:
Phase
Display message
Meaning
Duration
1
CHECK UP
Brazier cleaning cycle
Roughly 30
seconds
2
LOAD PELLET
Pre-loading of the brazier with pellets (continuous pellet loading) to fill the brazier
sufficiently to allow correct ignition
Roughly 4 minutes
3
FLAME STAND-BY
Stand-by for flame ignition after pre-loading (pellet loading suspended)
Roughly 4 minutes
4
FLAME STAND-BY /
LOAD PELLET
Loading of pellets into the brazier (intermittent pellet loading)
Not ascertainable
5
FLAME LIGHT
Flame stabilisation to allow uniform ignition of all pellets that were not burned in the
previous phases
Roughly 8 minutes
At the end of the ignition cycle, the appliance enters the work mode at the power set under “SET OUTPUT”.
MAC Address
Registration code
Summary of Contents for DIVA SLIM
