Instruction Manual
IDO
8065
-HILO
8065
24/08/15 Rev: 1.0.0 (TRANSLATION OF ORIGINAL LANGUAGE)
36
14.3.
DESCRIPTION OF CONTROL
RIDO
8065
and
HILO
8065
14.3.1.
ON/OFF KEY SWITCH (1)
It controls electrical power supply to the machine's functions. To switch on the machine,
turn the key to the ON symbol. When it is switched on with the key, the machine has
electrical system energised, flashing light on, the possibility to lift and lower the brush
plate.
14.3.2.
BRUSH ROTATION ACTIVATION SWITCH (2)
This switch controls brush rotation.
To start rotation, press the switch. The brush motor is powered and to start rotation just
press the accelerator pedal.
If the speed control pedal is at idle, the brushes and solution flow are stopped.
14.3.3.
EXTRACTION ACTIVATION SWITCH (3)
This switch controls activation of the extraction turbine.
To start extraction, press the switch.
If the brush plate is lifted, or the machine stops, the solution flow is interrupted and the
vacuum turbine is automatically disabled with a 5 second delay. This delay is to allow
the water recovered from the floor, contained in the extraction pipe, to be eliminated.
14.3.4.
BRUSH PLATE LIFTING SWITCH (4)
For
RIDO
8065
: The switch controls the ascent or the descent of the whole brushes
plate, including the wiper, in its two end stop stop positions.
For
HILO
8065
: The switch controls the ascent or the descent of the whole brushes
plate, including the wiper, in a variety of different positions, thus offering the possibility
to adjust the brush pressure on the floor according to the position chosen.
14.3.5.
BRUSH PRESSURE INDICATOR
Only for
HILO
8065
(5)
On HILO scrubber-dryer, the switch, described in the previous point, checks the
pressure exerted on the floor by the brushes. To decrease pressure, press the top of the
switch. To increase pressure, press the bottom of the switch.