Instruction Manual
IDO
8065
-HILO
8065
24/08/15 Rev: 1.0.0 (TRANSLATION OF ORIGINAL LANGUAGE)
30
first and second pass depends on the amount of dirt and type of chemical used.
A second pass with wiper and brushes lowered and activated solution further reduces
the layer of dirt. A further application of solution contributes to making a hard cleaning
operation mush easier.
When double washing passes are performed, it is recommended to maintain a
particularly low driving speed due to the wet floor and in order to allow the detergent to
chemically act on the dirt.
In the case of a double pass move the lever on UP.
Remember that:
RIDO : you can not only vacuum without rotating the brushes.
RIDO : you can vacuum without rotating the brushes.
13.5. EMPTYING AND CLEANING THE RECOVERY TANK
1. Press the switch on the control panel to lift the brush plate, stop the motor and flow of
solution and de-activate the extraction turbine.
2. Place the vehicle near a floor drain. The discharge pipe is at the rear of the machine.
3. Turn the ignition key to “OFF”, the parking brake is engaged.
4. Remove the drain hose from the hook. Unscrew the cap and lower the discharge pipe
towards the floor drain. Stay behind the end of the pipe. Lock the filthy water by
pressing the rubber; remove the cap from the drain hose slowly. The recovered solution
escapes with adjustable pressure from the rubber hose above mentioned.
5. Remove the upper tank cover.
6. Wash the recovery tank with clean water. Repeat washing until clean water issues
from the discharge pipe. Do not use water at temperature higher than 50°C as it might
damage the tank.
7. Replace the cap and the discharge pipe.
8. If the machine must be left inactive for a long period of time do not reassemble the
recovery tank upper cover and the drain hose cap, to allow air to circulate inside it.
