Instruction Manual
IDO
8065
-HILO
8065
24/08/15 Rev: 1.0.0 (TRANSLATION OF ORIGINAL LANGUAGE)
31
Dirty water drain hose with flow control (flow control)
13.6. EMPTYING AND CLEANING THE SOLUTION TANK
1. Place the vehicle near a floor drain. The discharge pipe is in the left front corner of
the machine, under the tank.
2. Turn the ignition key to “OFF”, the parking brake is engaged.
3. Remove the clip from the small discharge pipe connected to the solution tank.
The pipe is underneath the machine, on the left side. Lower the pipe towards the drain,
turn on the cock.
4. Wash the tank with clean water and run clean water into the system, until reaching
tank capacity (80 litres). Do not use water at temperature higher than 50º to clean the
tank as it might be damaged.
NOTE: Never leave the solution inside the tank as it might damage the tank, the seal
gaskets and the solenoid valves.
6. Replace the discharge pipe.
