Ecos
aire
®
CM Series Precision Air Conditioner Owners Manual
Startup Controller Interface
46
Ecos
aire
®
July 2007
Data subject to change without notice.
NOTE:
A remote-mounted display may initially show “NO LINK”. This will be corrected on the next page.
Prg
Esc
The Supervisaire
®
controller handles all the functions of the Ecos
aire
®
unit. The initial startup at
installation requires the manual input of the set points and permission to run. After this all functions
are fully automatic.
The
Esc
button is used to
revert to an earlier screen. It is
also used in combination with
the
Prg
button to access certain
service screens.
The backlit LCD screen dis-
plays any needed information
on the operation of the system.
The
↓
button is used for
scrolling downward to change
set points, enter passwords,
and select display screens
and menus.
The
↑
button is used for
scrolling upward to change
set points, enter passwords,
and to select display screens
and menus.
The
↵
button is used to navi-
gate through menu selections
and to accept changes.
The
Prg
button is used to
access the set point screens.
It is also used in combination
with the
Esc
button to access
certain service screens.
The button is used to announce and
to access any alarms that might arise.
This button illuminates to indicate a
current alarm condition. Pressing this
button brings up a sequence of current
alarm description screens.
Room Status
Temperature xx.x°F
Humidity xx.x%rh
Security
The Supervisaire
®
controller is protected by pass-
words. Set points, run enabling, and site-specific
setup values are protected by a User Password.
Detailed service settings and information are protected
by a Service Password. Model specific operation con-
stants are protected by a Factory Password.
Passwords are automatically cleared after two min-
utes pass with no button activity.
ST
ARTUP
