Klever X SPEED, User Manual

Page: 23 / 56

23 www.klever-mobility.com
Mounting the battery in the docking station
Insert the battery carefully into the guide rail, while the
groove of the battery casing must be carefully inserted into
the guide rail on the bicycle frame, and slide it gently down
until you hear the lock engage and the electronic contacts are
connected (image 13).
For this operation you do not need the key of the lock. The
lock will automatically snap in and the battery is now locked,
the system is ready for operation and the battery protected
from being stolen.
6.3.4 Transport of the battery
The battery is subjected to the Dangerous Goods Legislation.
The user can transport the battery by road and train without
any further requirements. When being transported by third
parties (e.g. forwarders, post or via air) special requirements
on Packing and labelling must be observed.
For the preparation of the battery being transported, consulting
an expert for hazardous material is absolutely required. Ship
the battery only when the casing is undamaged. Tape or mask
off open contacts and pack up the battery in such a manner
that it cannot move around in the packing. Please also observe
detailed national regulations.
In every case of transporting a broken or damaged
battery, always refer to an authorised bicycle dealer.
The dealer can inspect the battery and, in case necessary,
forward the broken battery to Klever Mobility
6.4 Diagnostics and troubleshooting
The system will not turn on.
Check whether the display is positioned firmly in the bracket.
Check all connections. Check whether the battery is sitting
correctly in the docking station in the frame and whether the
battery lock is engaged.
The display is fixed but the system will not turn on.
Check if you have installed the correct display.
The system can be turned on, but you do not have support.
Check all connections to the motor.
If it's not possible to solve the problem, please contact an
authorised dealer or our technical hotline.
The Klever Mobility propulsion
Image 12B
Image 13
Rubber
seal
Contact
connector