Klarstein 10034153, Manual, Page: 50 / 196

50
EN
Mounting the exhaust pipe
• The exhaust pipe outlet hole may be aligned horizontally to the heater
smoke outlet opening. In this case, the 1.5 m long flue pipe is laid outdoors.
You can also lay the 1.5 m long flue pipe on the inside (upwards to the
ceiling), in which case the outlet hole must be above the smoke outlet
opening of the heater.
• After inserting the flue pipe into the wall, the gap should be filled
and sealed with heat-resistant mineral fibre. Seal the hole with high
temperature resistant cement.
• Do not proceed with the installation until the cement has solidified.
• Below is a standard installation drawing for reference. In this case, the
1.5 m long pipe is laid in the interior:
Support bracket
Termination cap
Wall thimble
Floor protection plate
Chimney pipe
Combustion air connection
(Minimum diameter 50 mm)
Clean out
cover