kiwy SP1 SA-ATS, Instruction Manual

Page: 11 / 130

9
protection.
• In case of buckle malfunction, do not use this seat and
consult your detailer.
VII. carE & maIntEnancE InstructIons
! warning! Never lubricate any component of your child
seat, just keep it nice and clean.
• Plastic parts can be easily cleaned by using just soapy
water; never use solvents, alcohol or any harsh cleaning
agents.
• Cleaning: when your cover gets dirty, remove it (see be-
low) and hand-wash it at 30°; do not use chemical clea-
ners; do not machine-wash; do not wring, nor tumble-
dry; do not iron. Please observe the instructions on its
washing label.
rEmoVInG thE FabrIc coVEr:
1. Loosen the shoulders’ straps as much as possible.
2. Grip the lever (P) in the front to recline completely the seat.
3. Undo the shoulder straps behind the backrest (Fig. 23
and 24) and slide them both through the slots in the
backrest and the headrest from the front of the child seat
and through the shoulders’ pads (Fig. 25).
4. Turn outwards the plastic strips sawn on the left and
right sides of the cover edges and unhook the cover in
the front.
5. Open the harness buckle.
6. Remove the cover of the headrest and the strap pads
(Fig. 26).
7. Slide the cover off the harness buckle and the seat.
rE-FIttInG thE coVEr:
Follow the reverse procedure of removal above, making
sure to thread correctly the shoulder straps and not to twist
them.
matErIals
Frame: Polypropylene – High density Polyethylene - Pol-
yamide - Steel
Cover: 100% Polyester
mEasurEmEnts
L: 49 cm - H: 71 cm - W: 44 cm.
GB