KITO Harrington RY Series, Owner'S Manual

Page: 34 / 120

34
Table 3-9 Load Limiter Setting Values

•
Follow the procedure described below to properly perform settings. The range of values (upper and
lower limits) that can be set depends on the model. Values that are not included in this range cannot be
registered.
Operational Step LED Display
1. Energize the hoist.
Default Screen
2. Press until the “Setup Mode” screen is displayed (blinking).
3. Press to display the parameter setting screen (blinking).
Parameter
Setting Screen
4. Press or until the desired parameter, Low Speed: S1-38 (shown at right,
blinking) or High Speed: S1-41, is displayed). (*Be sure to set both the low- and high-
speed parameters.)
5. When you press , the initial setting value is displayed (digit selected blinks), as
shown in the following Table 3-10 .
The highest digit
will blink.
Table 3-10 Default Setting Values
200V = 208 – 230V/400V = 415 – 460V
Capacity
(T)
Product Code
Default Settings
200V 400V
S1-38 S1-41 S1-38 S1-41
Low
Speed
High
Speed
Low
Speed
High
Speed
3
RYU030A
106 113 111 115
5
RYU050B
103 107 114 108
(*Be sure to reset the values to these default values after the load test is finished.)
6. Press to move the blinking digit to the desired digit. (Example Value: 1 blinks)
7. Press or to register a value shown in Table 3-11 so that the LL will not be activated even when a
load that is 1.25 times heavier than the capacity is applied. If fine tuning is necessary, change the value to
a desired one.