Kitett MINIKIT DUO, Instructions For Use Manual

Page: 13 / 78

13
•
Do not use the device outside, near a heat source or near a water source (bathtub, sink, etc.).
•
Make sure the equipment is not directly exposed to the sun or excessive heat.
•
After use, unplug the appliance from the wall outlet.
•
If you find that the device is noisy or malfunctioning, contact DTF MEDICAL or your local supplier.
•
Fragile medical equipment, to be handled with care.
•
No special knowledge or training is required to operate this equipment. Read the operating instructions carefully
before using.
•
Keep these instructions in a safe place with the appliance as they contain the information necessary for the proper
use of the equipment.
•
The device can be worn on a belt using the clip during use.
•
This device is to be used at home or in a public place.
•
The user can safely use all the functions of the device.
WARNINGS:
•
DO NOT TOUCH BATTERIES DURING AND AFTER OPERATION OF THE DEVICE.
•
DO NOT TOUCH THE PINK DEVICE FOR MORE THAN 10 SECONDS WHILE THE APPLIANCE IS OPERATING.
•
DO NOT TOUCH THE POWER SUPPLY FOR MORE THAN 1 MINUTE WHILE THE APPLIANCE IS OPERATING.
•
THE TEMPERATURE OF THE BREAST SHIELD CAN REACH 42.5°C WHILE THE APPLIANCE IS OPERATING
Notes on the functionality of the breast pump
•
The breast shield with an international screw thread can only be used with a corresponding collection container (same
screw thread).
•
Switch off the appliance when the collection container(s) is (are) filled to prevent milk from getting inside the
protective membrane.
CAUTION: in all cases:
•
ALWAYS UNPLUG THE POWER CORD BEFORE OPENING THE DEVICE.
•
CAUTION, ONLY AUTHORISED SERVICE PERSONNEL ARE AUTHORISED TO SERVICE A DEVICE.
•
MODIFICATION PROHIBITED.
•
USE ONLY THE ACCESSORIES SUPPLIED AND REFERENCED IN THE MANUAL.
•
THIS WARRANTY DOES NOT COVER CONNECTION ERRORS WITH NON-COMPATIBLE ACCESSORIES.
7. Troubleshooting
Problem Solution
The display screen of the
device does not light up
•
Make sure that the power cord is connected to the mains and to the unit.
•
Press the “ON/STANDBY” button again.
•
Check that the current delivered by the mains corresponds to that of the device (Volt (V)
Hertz (Hz)).
•
Check with another device if a power supply is available in the wall outlet.
•
If the device still does not light up, contact DTF MEDICAL or your local supplier.
Low or no suction
•
Check that the breast shield is fully screwed onto the collection container (screw tightly).
•
Check that the “Clean Valve” transparent valve specific to the MINIKIT DUO breast pump
is present.
•
Check that the membrane is correctly positioned on the intermediate ring of the valve.
•
Check that the protective membrane is correctly positioned in its housing.
•
Check that the tubing is properly connected and not bent.
•
Check the condition of the O-ring between the breast shield and the collection container.
•
Check there is no residue in the tubing.
•
When using double pumping mode, check that the selector is correctly positioned.
•
If the problem persists, contact DTF MEDICAL or your local supplier.
The suction is too strong
despite decreasing suc-
tion with the
⊝
button
•
Deactivate the breast pump then turn it on.
•
If the problem persists, contact DTF MEDICAL or your local supplier.
The breast pump sucks
continuously
•
Do not pull the breast shield off your breast (risk of pain and injury).