Kitett MINIKIT DUO, Instructions For Use Manual

Page: 10 / 78

10
WARNINGS:
•
If the device is clipped to the belt and used on mains power, the power plug may be pulled out of the device and
may damage it. Also, please restrict your movements to avoid any risk of falling. When used on mains power, it is
preferable to place it flat on a stable support (e.g. table).
•
Do not use a power supply other than that supplied in the kit.
2. Operation on batteries:
•
Remove the screw located at the bottom of the back of the device (on the battery
compartment) and open the cover.
•
Insert the batteries according to the diagrams shown in the compartment.
•
Close the compartment and re-tighten the screw before switching on the appliance.
NOTES:
•
The unit operates with 4 LR6 1.5V alkaline batteries.
•
The battery-operated MINIKIT DUO breast pump operates autonomously for 30 minutes (2 to
3 expression sessions).
Special cases:
•
It is not necessary to remove the batteries when the unit is operated on mains power.
•
Check the condition of the batteries in the compartment regularly.
•
Replace the batteries when the performance of the breast pump is reduced.
•
If the device is not used for an extended period of time, remove the batteries from the compartment.
•
Do not use the device if the cover is not in place.
•
The battery level is indicated on the display screen of the device.
b. Preparation of accessories
NOTES:
•
Use only the accessories supplied in the kit or those manufactured by DTF MEDICAL.
•
Before use, check that the MINIKIT DUO components do not show any defects, damage or signs of wear. If this is the
case, replace them.
•
All components must be completely dry before use.
Before first use, refer to Chapter 3 for cleaning and disinfection.
1. Wash your hands in soapy water before handling breast pump components.
2. Position the collection container directly onto the transparent “Clean Valve” (the valve must be placed on a flat,
clean surface).
In order to respect hygiene, both parts of the valve have been assembled during cleaning: white membrane and
transparent intermediate ring (see chapter 3).
If necessary, take care to handle the «Clean Valve» by the rim (taking care not to touch parts that may be contact
with breast milk). The innovative technology of the «Clean Valve», exclusive to KITETT®, prevents the risk of
contamination through contact with fingers in the breast shield.
3. Screw the KOLOR® breast shield with the valve onto the collection container.
4. Connect the small tube connected to the protective membrane to the breast shield. Connect the intermediate-
size tube to the protective membrane and to the selector. Place the assembled breast pump on the collection
container stand for optimal stability.
5. Then connect the large tube of the selector to the device.
6. When using in single pumping mode, position the selector switch to the right or the left according to the breast
chosen for expression. When using in double pumping mode, position the selector switch in the middle.
Repeat the operation on the second breast shield when using in double pumping mode.
WARNING: Never use the breast pump in single pumping mode without connecting the selector.