6-15
Figure 13. Discharge the blower capacitor
at right side of blower motor housing.
b) Remove the wires from the hook in the
blower motor housing. See Figure 13.
c) Pull the blower motor housing assem-
bly far enough forward so you can ac-
cess the lint drawer switch. See Fig-
ure 11.
d)
IMPORTANT:
Discharge the blower
capacitor by touching a 20,000 Ω re-
sistor to the terminals and chassis.
See Figure 13.
e) Remove the blower motor top housing
cover screws and position the assem-
bly out of the way.
f) Disconnect the two yellow wires from
the lint drawer switch terminals.
g) Bend the three lint drawer switch’s
metal tabs straight out.
h) Release the bottom and top locking
tabs on the switch and push it out of
its housing cutout.
7.
To remove the blower motor:
a) Remove the blower motor housing as-
sembly and the top housing cover by
following steps 6a through 6e.
b) Remove the four 3/8
˝
(7mm) nuts,
split washers, and flat washers from
the top blower motor housing. Lift the
top housing off the motor, and position
it to the left side.
c) Release and disconnect the following
connectors:
2 blower motor harness connectors
2 blower motor harness plugs from
the mounting bracket
3 blower capacitor wires
d) Turn the blower motor assembly over,
and position it so that you can access
the bottom screws.
e) Remove the four 3/8
˝
(7mm) motor
mounting plate nuts, and the five mo-
tor mounting screws from the blower
motor assembly.
f) Remove the mounting plate and pull
the motor wiring through the opening.
g) Lift the motor and fan from the housing.
•
•
•
Summary of Contents for KHEV01RSS - Pro Line Plus Electric Dryer
Page 112: ......
