4-14
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the toe panel from the front of the
dryer (see page 4-6 for the procedure).
REMOVING THE BLOWER CAPACITOR
AND THE LINT FILTER SWITCH
4.
To remove the blower capacitor (see
the top right photo):
a) Pull the capacitor boot off the front of
the blower capacitor. Be careful not to
touch the bare capacitor or wire termi-
nals.
b)
IMPORTANT:
Discharge the capacitor
by touching a 20,000
Ω
resistor to the
terminals and the chassis.
c) Disconnect the brown and two black
wires from the blower capacitor termi-
nals. Note that the black wires connect
to the terminals with the black insula-
tor, and the brown wire to the terminal
with the white insulator.
d) Loosen the 5/16
˝
mounting screw
from the capacitor bracket, and re-
move the capacitor from the bracket.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Loosen
Screw
Brn Wire
Blower Capacitor
Blower Capacitor
Blk Wire
Boot
Blk Wire
White
Insulator
Black
Insulator
5.
To remove the lint filter switch:
a) Remove the rear panel from the dryer
(see page 4-12 for the procedure).
b) On the rear of the blower assembly,
disconnect the two yellow wires from
the lint filter switch terminals.
c) Remove the two hex nuts from the lint
filter switch bracket studs and remove
the switch from the blower.
Yel Wires
Blower Assembly
Lint Filter Switch Nuts
Summary of Contents for KHEV01RSS - Pro Line Plus Electric Dryer
Page 112: ......
