2-3
WARNING
Explosion Hazard
Keep flammable materials and vapors,
such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm)
above the floor for a garage installation.
Failure to do so can result in death,
explosion, or fire.
You will need
A location that allows for proper exhaust
installation. See “Venting Requirements,”
page 2-15.
Electric Models Only: A separate 30-amp
circuit.
If you are using a power cord, a grounded
electrical outlet located within 2 ft (61 cm)
of either side of the dryer. See “Electrical
Requirements,” pages 2-5 & 2-13.
A sturdy floor to support the total dryer
weight of 250 lbs (113.4 kg). The combined
weight of accessories, clothes loads, and
companion appliances should also be con-
sidered.
A level floor with a maximum slope of 1
˝
(2.5 cm) under entire dryer. Clothes may
not tumble properly and automatic sensor
cycles may not operate correctly if dryer is
not level.
For a garage installation, you will need to
place the dryer at least 18
˝
(46 cm) above
the floor. If using a pedestal, you will need
an additional 7
˝
(17.8 cm).
•
•
•
•
•
•
LOCATION REQUIREMENTS
Do not operate your dryer at temperatures
below 45
°
F (7
°
C). At lower temperatures, the
dryer might not shut off at the end of an auto-
matic cycle. Drying times can be extended.
The dryer must not be installed or stored in an
area where it will be exposed to water and/or
weather.
Check code requirements. Some codes limit,
or do not permit, installation of the dryer in
garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspec-
tor.
NOTE:
No other fuel-burning appliance can
be installed in the same closet as a dryer.
Installation Spacing
The following spacing dimensions are recom-
mended for this dryer. This dryer has been
tested for spacing of 0
˝
(0 cm) clearance
on the sides, front, and rear. Recommended
spacing should be considered for the follow-
ing reasons:
The location must be large enough to allow
the dryer door to open fully.
Additional spacing should be considered
for ease of installation and servicing.
Additional clearances might be required for
wall, door and floor moldings.
Additional spacing should be considered
on all sides of the dryer to reduce noise
transfer.
Companion appliance spacing should also
be considered.
NOTE:
This dryer cannot be stacked on the
washer.
•
•
•
•
•
Summary of Contents for KHEV01RSS - Pro Line Plus Electric Dryer
Page 112: ......
