2-23
INSTALLING THE DRYER ON THE PEDESTAL
Excessive Weight Hazard
Use two or more people to move and
uninstall dryer.
Failure to do so can result in back or
other injury.
WARNING
IMPORTANT:
If the dryer is already installed,
it must be uninstalled. See Installation Instruc-
tions that came with the dryer for tools re-
quired.
1.
Unplug dryer or disconnect power.
2.
Gas Dryers Only:
Turn off the gas supply.
3.
Pull the dryer away from the wall enough
to loosen the vent clamp. Loosen the
clamp and carefully remove the exhaust
vent from the dryer exhaust outlet.
4.
Gas Dryers Only:
Disconnect the flexible
gas supply line from the dryer. Put a piece
of tape over the open ends of the gas line
connection fittings.
5.
Pull the dryer away from the wall so it can
be tipped on its back.
6.
Protect the floor with a large piece of
cardboard cut from the pedestal carton.
Lay the dryer on its back so that the
cardboard is under the entire lower back
edge.
13"
(33 cm)
27"
(68.6 cm)
18-9/16"
(47.2 cm)
23-5/8"
(60 cm)
2-5/8"
(6.7 cm)
Explosion Hazard
Keep flammable materials and vapors,
such as gasoline, away from dryer.
Place dryer at least 18 inches (45.7 cm)
above the floor for a garage installation.
Failure to do so can result in death,
explosion, or fire.
UNINSTALLING THE DRYER
WARNING
IMPORTANT:
Check that all four pads are
present, as shown. If they are not, do not
install the pedestal, and contact your dealer.
Summary of Contents for Ensemble KEHS01PMT/WH
