3-2
• Press the EXTRA CARE feature button, if
this option is desired.
• Press the CYCLE END SIGNAL button to set
the signal volume to the desired level.
• Press and hold the HOLD TO START button
until the dryer starts (about 1 second).
Once an Automatic cycle has started, the Extra
Care feature and the Cycle End Signal level
can be adjusted. Press the OFF button twice to
stop the dryer and clear the settings, allowing
you to select another cycle and dryness level.
To use a Manual Cycle:
• Rotate the dial to select a Manual Cycle.
• Press the MANUAL DRY TIME (– or +)
buttons until the desired drying time is dis-
played. Tap – or + and the time will change
by 1-minute intervals. Press and hold – or +
and the time will change by 5-minute inter-
vals. The initial time displayed is the actual
drying time.
STOPPING THE DRYER
To stop the dryer at any time:
Press OFF twice or open the door.
PAUSING OR RESTARTING
To pause the dryer at anytime:
Open the door or press OFF once.
To restart the dryer:
Close the door and press and hold the HOLD
TO START button until the dryer starts.
NOTE:
Drying will continue from where the
cycle was interrupted if you close the door and
press START within 5 minutes. If the cycle is
interrupted for more than 5 minutes, the dryer
will shut off. Select the new cycle settings
before restarting the dryer.
CONTROL LOCKED
This feature allows you to lock your settings to
prevent unintended use of the dryer. You can
also use this feature to prevent unintended
cycle or option changes during dryer opera-
tion.
To enable the Control Locked feature when
the dryer is running:
Press and hold the CYCLE END SIGNAL but-
ton for 3 seconds. The control is locked when
a single beep is heard and the Control Locked
status light is on.
• When the dryer is off, it is not necessary to
press the CONTROL ON button before acti-
vating the Control Locked feature.
To unlock the Control Locked feature:
Press and hold the CYCLE END SIGNAL but-
ton for 3 seconds to turn this feature off.
NOTE:
When the dryer is running and Control
Locked is on, the dryer can be stopped by
pressing the OFF button, but cannot be re-
started until the control is unlocked.
NOTE:
The Manual Dry Time feature can only
be used with Manual Cycles.
• Press TEMP until the desired temperature
glows.
NOTE:
Pressing the DRYNESS LEVEL button
will cause the triple beep, indicating that this
option is not selectable. Also, a dryness level is
not indicated.
• Press the EXTRA CARE feature button if this
option is desired.
• Press the CYCLE END SIGNAL button to set
the volume to the desired level.
• Press and hold the HOLD TO START button
until the dryer starts (about 1 second).
During a Manual Cycle, you can change the
settings for Time, Temperature, the Extra Care
feature, and the Cycle End Signal. Press the
OFF button twice to stop the dryer and clear the
settings, allowing you to select another cycle.
Summary of Contents for Ensemble KEHS01PMT/WH
