Pole Pruner/ Palm Harvester
KK-PP2-8627/ KK-PH2-215
: www.kisankraft.com
: +91.80.22178200
Page 16 of 56
Cutting above obstacles:
The unit's long reach makes it possible to prune
branches that are overhanging obstacles, such as rivers
or lakes. The tool angle in this case depends on the
position of the branch.
Cutting from a lift bucket:
The unit's long reach enables cutting to be performed
next to the trunk without the risk of the lift bucket
damaging other branches.
The tool angle in this case depends on the position of the
branch.
Mounting the Bar and Chain
Removing the chain sprocket cover:
Unscrew the nut and remove the cover.
Turn the screw (1) counterclockwise
until the tensioner slide (2) butts against
the left end of the housing slot, then
back it off 5 full turns.
Guide-bar and chain adjustments can only
be made with the engine stopped.
Fitting the chain:
Wear work gloves to protect your hands
from the sharp cutters.
Fit the chain
–
start at the bar nose.
Fit the guide bar over the screw (3) and engage
peg of tensioner slide in the hole (4)
–
place the
chain over the sprocket (5) at the same time.
Turn the tensioning screw (1) clockwise until
there is very little chain sag on the underside of
the bar
–
and the drive link tangs are engaged
in the bar groove.
Refit the cover and screw on the nut finger tight
and refer to "Tensioning the Saw Chain".
