Pole Pruner/ Palm Harvester
KK-PP2-8627/ KK-PH2-215
: www.kisankraft.com
: +91.80.22178200
Page 25 of 56
Erratic idling behavior, engine stops even though setting of LA-screw has been
corrected, poor acceleration. Idle setting is too lean
Turn the low speed screw (L) counterclockwise, no further than stop, until the
engine runs and accelerates smoothly. Erratic idling behavior .Idle setting is too
rich
Turn the low speed screw (L) clockwise, no further than stop, until the engine
runs and accelerates smoothly.
If the chain continues moving when the engine is idling, have your saw machine and
repaired by your servicing dealer.
Spark Arresting Screen in Muffler:
If the engine is down on power, check the spark arresting screen in the muffler.
Wait for the muffler to cool down.
Move the slide control to STOP.
Take out the screw (1).
Take out the screw (2) and remove
the shroud (3).
Take out the screws (4).
Lift the spark arresting screen (5)
and pull it out.
Clean the spark arresting screen. If
the screen is damaged or heavily
carbonized, fit a new one.
Refit the spark arresting screen.
Insert the screw and tighten it down
firmly.
Fit the shroud.
Spark Plug:
If engine is down on power, difficult to start or runs poorly at idling speed, first check the
spark plug. Fit a new spark plug after approx. 100 operating hours or earlier if the
electrodes are badly eroded. Wrong fuel mix (too much engine oil in the gasoline), a dirty
air filter and unfavorable running conditions (mostly at throttle part etc.) affect the
condition of the spark plug. These factors cause deposits to form on the insulator nose
which may result in trouble in operation.
Removing the spark plug:
Move the slide control to STOP.
Pull off the spark plug boot (1).
Unscrew the spark plug.
