Pole Pruner/ Palm Harvester
KK-PP2-8627/ KK-PH2-215
: www.kisankraft.com
: +91.80.22178200
Page 11 of 56
37. Make periodic inspections to assure safe and efficient operation. For a thorough
inspection of your machine, please contact a dealer.
38. Keep the machine away from fire or spark.
39. It is believed that a condition called Raynaud's phenomenon, which affects the
fingers of certain individuals may be brought about by exposure to vibration and
cold. Exposure to vibration and cold may cause tingling and burning sensations
followed by loss of color and numbness in the fingers. The following precautions
are strongly recommended because the minimum exposure which might trigger
the ailment is unknown.
40. Check for fuel leakage while refueling and during
operation. If fuel leakage is found, do not start or run the
engine until the leak is fixed and any spilled fuel has been
wiped away. Take care not to get fuel on your clothing. If
this happens, change your clothing immediately.
41. It is needed for daily inspection before use and after dropping or other impacts in
order to identify any significant damage or defects
42. Unit vibrations can cause an improperly tightened fuel
filler cap to loosen or come off and spill quantities of fuel.
In order to reduce the risk of fuel spillage and fire, tighten
the fuel filler cap by hand as securely as possible.
43. To reduce the risk of fire and burn injuries, start the engine at least 10 feet (3 m)
from the fueling spot, outdoors only. Start and operate your machine without
assistance. For specific starting instructions, see the appropriate section of your
manual. Proper starting methods reduce the risk of injury. Place the machine on
firm ground or other solid surface in an open area or, in the alternative, as shown
in the above picture. Maintain good balance and secure footing.
44. Always hold the unit firmly with both hands on
the handles while you are working. Wrap your
fingers and thumbs around the handles. Place
your left hand on the shaft and your right hand
on rear grip and throttle trigger. Left-handers
should follow these instructions, too. Keep your
hands in this position to have your machine
under control at all times.
45. Never attempt to operate your power tool with one hand. Loss of control of the
power tool resulting in serious or fatal injury may result.
