7
INSTALLATION
INSTALLATION
Attach the Magnetic Valance Clips to the Valance
The magnetic valance clips are adjustable for quick and easy valance attachment and have multi-position valance adjustment
capabilities.
■
To install the clips, lay the valance face down on a protected surface with the back side up.
■
Insert the clip dovetail into the valance groove.
■
Twist the clip until it is straight with the clear tabs at the top of the valance.
➤
There are at least two clips per valance. For valances narrower than 36", position clips 5
1
⁄
2
" in from the ends of the valance.
For valances 36" or wider, position the clips 10" in from the ends of the valance. Additional clips should be spaced evenly
between the two end clips.
Attach the Corner Clips (If Required)
If the valance came with returns, connect the returns to the valance using the corner clips
provided.
■
The notches on the rear of the valance and returns fit into the grooves of the corner clips.
■
Slide one end of each clip onto the rear of the valance until the center of the clip aligns with
the edge of the miter cut at each end.
■
Slide a return onto each corner clip until its miter is flush against the miter on the valance.
Attach the Valance Splice (If Required)
For valances that are spliced, join the two mitered valance pieces together by sliding the
valance splice clip over the back of the valance where the two halves meet.
Miters Meet
Valance
Valance
Return
(Cross-
Section)
Corner
Clip
Notch
Notch
Miters
Valance
Splice Clip
