11
INSTALLATION
INSTALLATION
Attach the Valance with Magnetic Valance Clips
■
Align the valance to the headrail.
■
Hold the valance securely from the front side with both hands.
■
Position the clips to the top-front lip of the headrail until it is level and in position.
■
Press the valance gently forward, just enough so the clips adhere to the headrail.
■
The magnetic valance clips allow for limited valance height adjustments by carefully
sliding the clip up or down while the magnets are adhered to the headrail. The clip’s tabs
rest on the top-front lip of the headrail, keeping the valance level and preventing the
valance from adjusting lower beyond that point.
■
To remove the valance, gently pull the valance up and toward you.
CAUTION:
The entire surface area of the magnet inside each clip needs to maintain clean contact with the front surface area
of the headrail at all times.
Attach the Hold-Down Brackets (Optional)
The bottom rail will come with pre-drilled
3
⁄
32
” holes and hold-down pins that have been inserted in the center of the bottom rail
ends.
NOTE:
Bottom rail design varies by product.
■
To mount the hold-down brackets, first fully lower the blind. Align the hold-down brackets with the hold-down pins in the
bottom rail.
■
Use the first slot with the 2½” slat size.
■
Use the second slot with the 2” slat size.
■
Maintain the correct slot alignment as you attach the hold-down brackets to the jamb, sill, or outside mounting surface.
■
Slide the hold-down pins into the appropriate slot or hole on the hold-down brackets.
■
If necessary with 2” outside mount blinds, the first slot of the hold-down brackets may be used in place of a spacer block.
Testing the Blind
Testing the blind with the control button will allow you to ensure that the motor
and power source are working correctly.
■
Press the control button on the front side of the headrail to test operation. If
the blind does not operate see “Troubleshooting” on page 14.
The control button can also be used in combination with the Automation App for
control of advanced blind functions and home access. Open the App, then press
and hold the control button to see a list of available functions. See “Using the
Automation III Remote” for more information.
Jamb
Mount
Second
Slot
First
Slot
Sill
Mount
Outside Mount
1
3
∕
8
", 2", and 2
1
∕
2
" Slat Sizes
Control
Button
Front of
Blind
Transceiver
Assembly
