15
INSTALLATION
TROUBLESHOOTING
Problem
Rechargeable battery needs recharging (continued).
Solution Recharging Via the Dual Charging Station
■
Plug the dual charging station into a standard AC outlet.
■
Insert the nose of the rechargeable battery wand into one of the slots of the dual
charging station.
■
The battery will firmly snap into place. A red light indicator on the front of the
charging station will turn on when the battery wand has been properly inserted
and being charged.
■
Once the battery has been fully recharged, the red light indicator will turn green.
Charging may take up to three hours, depending on your battery level.
■
Remove the battery wand from the charger.
Recharging Via the Single Charger
Remove the rechargeable battery wand from the mount, or insert the single charger
cable without removing from the shading.
■
Attach the plug adapter to the charger.
■
Plug the charger into a standard AC outlet.
■
Plug the charging cable into the charging outlet on the rechargeable battery wand.
The charging outlet is near the nose of the wand.
■
A red light indicator confirms the battery wand is properly inserted and is charging.
CAUTION:
Do not attempt to plug the charging cable into the battery mount’s
power socket. Doing so will not only fail to charge the battery wand but could possibly
cause damage to both the single charger and the battery mount.
■
Once the battery has been fully recharged, the red light indicator will turn green.
Charging may take up to two hours, depending on your battery level.
■
Remove the charging cable from the battery wand.
Reinserting the Rechargeable Battery Wand into the Mount
■
Match the direction of the arrow on the underside of the battery wand with the arrow on the battery mount.
■
Insert the nose of the battery wand into the cavity of the battery mount.
■
Push the battery wand flush into the mount until the battery snaps into place.
Problem
The blind does not raise or lower evenly.
Solution
Check inside the headrail. Make sure no obstructions keep the mechanism from turning.
Check that the lift cords are not pinched or tangled.
Problem
Lift cords are bunching by the safety cord connector.
Solution
Make sure the slats are in the open position. Raise and lower the blind to straighten the lift cords.
Problem
Lift cords are stuck or jammed.
Solution
Check the cords and the moveable pin in the cordlock mechanism inside the headrail of the blind. Make sure the
cords can move freely. If the cords are jammed, use a screwdriver or needle-nose pliers to move the pin and free the
cords.
Not this
socket
