Optional Accessories
CLEANING THE CARPET SHAMPOO
SYSTEM (cont)
8
To remove the Shampoo Tank from the Air Exhaust
Port (19), rotate it away from the Sentria
™
system as
far as it will go, then lift it upwards. >
9
Remove and clean the Suds Screen Cap, Cup and
Sponge Filter.
Rinse out the Shampoo Tank with cold water and
replace the Screen Cap, Cup and Sponge Filter.
NOTE: The belt should not be stretched for extended periods.
Make sure the green arrows on the nozzle line up for storage.
(Remember to align the red arrows before replacing the nozzle
on the unit - see Belt Lifter section on page 10.) •
REPLACING A WORN CARPET SHAMPOO
SYSTEM NOZZLE BELT
1
To replace the Carpet Shampoo System Nozzle Belt,
push the thumb pads located at each end of the shield
and rotate the shield up and away from the brush. >
2
Push down carefully on the ends of the brush with
your thumbs. The brush will snap out and the belt
can be replaced.
Be certain the belt is placed in the center of the brush.
NOTE: Use only approved Kirby
®
belts. >
35
