Operating/Maintenance Tips
ADJUSTING THE BRUSH ROLL HEIGHT (cont)
1
Remove the Power Nozzle (25) from the Sentria system. >
Release the belt tension by using the handle on
the Belt Lifter (20) to turn it all the way to the right
(clockwise) until the green arrows line up.
Unlock the two latches on the rear of the Power Nozzle to
remove the Rug Plate (26).
Then lift the brush out of the nozzle. >
3
Rotate the plastic Brash Roll ends to the 1,2 or 3-notch
settings as desired. The greater the number of notches,
the farther the bristles are extended.
When viewed from the top, rotate the plastic Brush Roll ends
to the side with the appropriate number of notches visible.
Make sure both plastic Brush Roll ends are set to the same
number of notches. >
4
Place the brush back into the nozzle making sure both
plastic Brush Roll ends are set to the same number of
notches (1, 2, or 3).
Replace the Rug Plate by placing it on the front of the bum-
per first and then pulling it over the bumper on rear of Power
Nozzle (25). Secure the Rug Plate using the two latches that
hold it in place.
Using the handle, hook the belt onto the Belt Lifter (20) and
turn the Belt Lifter to the left (counter-clockwise) until the
red arrows line up. This will stretch the belt in preparation
for returning the nozzle to the Sentria
™
system. •
Keep the entire Brush Roll and belt track clear of lint, string,
hair and other fibers. This will allow the Brush Roll to perform
to its fullest potential.
SERVICE TIP:
Keep the entire Brush Roll and belt track clear of lint, string,
hair and other fibers. This will allow the Brush Roll to perform
to its fullest potential.
Keep the entire Brush Roll and belt track clear of lint, string,
hair and other fibers. This will allow the Brush Roll to perform
to its fullest potential.
57
2
