Please read the Operation Instructions carefully for safety.
1.2 Notes to pre-start
1) Hold rails tightly to avoid the slip. Do not
jump on or down the loader. It is danger! Do
not hold operating levers when entering or
leaving the cab.
2) Adjust the seat properly. Improper seat causes
wrong operation and fatigue even unexpected
incidents.
3) Please check followings before starting the
engine.
·Check if any person is around the loader.
·Sit in the driver cab before startup.
·Check if operating levers are at the neutral
position
·Check if shovel touches the ground and stop
brake is normal.
·Check if any inflammable materials around the
engine.
4) Check working conditions of bucket, moving
arm, driving and turning after engine starts in
place free of person and block. If any
abnormality, settle and repair it.
1.3 Notes to operations
1) Sit in the cab and drive the loader correctly.
Do not gaze around, jump on or down the cab
during driving. Forbid unessential operators in
the cab.
2) Do not use it for unintended applications.
Otherwise it may not only damage the loader but
also cause unexpected incidents.
3) Check if the loader is exposed to any danger
before start. Increase the rotation speed of
engine and drive the loader slowly. Do not start
and drive the loader quickly.
4) Prohibit the entry of any person in the
operating area.
5) Fix the bucket tightly when loader runs on the
road or a long distance. Unintentionally touching
the operating lever will change the pose of
running loader, leading to incidents. The correct
pose of running loader is to keep bucket about
40m above the ground.
6) Abnormal drive such as quick start, brake,
rotation, driving in the zigzag form and high speed
will contribute to the turnover of loader and cause
serious injury even death. In particular, quick
rotation of loader at high speed can cause the
turnover to side. It is extremely dangerous.
7) Lower the bucket as much as possible when
loader delivers the sand to keep the center of
gravity at a low level. Loader cannot keep the
balance if bucket of running loader is raised
beyond the upper limit. Loader is exposed to
the danger due to higher center of gravity.
8) Uneven operating area may contribute to one
factor of turnover incident. Therefore select the
flat operation ground for driving. If there is any
stone or obstacles on the route, do not pass it by
inclining loader or at high speed. Such incorrect
operation may lead to turnover. The correct way
is to reduce the speed and run across an obstacle
when stability of loader is ensured. Check the
capacity of load of bridge or structure before
loader drives on it. If capacity of load is
insufficient, strengthen it.
9) Avoid any operation along a slope as much as
possible. Loader will lose balance and be
exposed to danger if excavating the inclined
section.
2
Summary of Contents for KDD03
Page 2: ......
