KIPI ecoMAX920 P1-CH, Operating And Installation Manual

Page: 4 / 34

4
1 Safty advices
Safety requirements are specified in
individual sections of this manual. Apart from
them, in particular, the following
requirements must be observed.
• Before starting assembly, repairs or
maintenance and during any connection
works, it is absolutely necessary to
disconnect the mains power and make sure
that the terminals and electric wires are not
switched on.
• After the regulator is turned off, dangerous
voltage may occur on its terminals.
• The regulator cannot be used contrary to
its purpose.
• The controller is designed to be built-up.
• The regulator is intended for the
manufacturer of the furnace. Before using
the regulator, the manufacturer should check
whether the regulator's cooperation with a
given type of stove is correct and does not
cause any danger.
• The regulator is not an intrinsically safe
device, ie in a failure condition it can be
a source of a spark or high
temperature, which in the presence of
flammable dusts or gases may cause a
fire or explosion.
• The surroundings of the controller should
be kept clean.
• The controller must be installed by the
furnace manufacturer in accordance
with the applicable standards and
regulations.
• Modification of the programmed
parameters should be carried out only
by a person who read this manual.
• The electrical installation, in which the
regulator operates, should be protected
with a fuse selected appropriately to
the applied loads.
• The regulator cannot be used with a
damaged casing.
• The structure of the regulator may not be
modified under any circumstances.
• The controller uses electronic disconnection
of connected devices (operation type
2Y in accordance with PN-EN 60730-1)
and micro-disconnection (operation
type 2B in accordance with PN-EN
60730-1).
• Access of unauthorized persons, especially
children, to the regulator must be
prevented.