KIPI ecoMAX920 P1-CH, Operating And Installation Manual

Page: 23 / 34

23
not exceed 220 °
C.
Connecting the exhaust gas temperature sensor: 1 -
exhaust gas temperature sensor, CT2S type, 2 - sensor
lead, 3 - flue.
Opening the furnace door may
cause the exhaust gas temperature
to
rise above the thermal
resistance of the sensor, it may
burn out the sensor.
5.5 Checking temperature sensors
Temperature sensors can be checked by
measuring their resistance at a given
temperature.
In case of significant
differences between the measured resistance
value and the values from the table below,
the sensor should be replaced.
A very accurate multimeter should be used
to check the CT2S sensor, otherwise the
sensor can only be checked roughly.
CT4
External
Temp.
°C
Min.
Ω
Nom.
Ω
Max.
Ω
0 802 815 828
10 874 886 898
20 950 961 972
25 990 1000 1010
30 1029 1040 1051
40 1108 1122 1136
50 1192 1209 1225
60 1278 1299 1319
70 1369 1392 1416
80 1462 1490 1518
90 1559 1591 1623
100 1659 1696 1733
CT6-P (weather)
External
Temp. °C
Min.
Ω
Nom.
Ω
Max.
Ω
-25 901,6 901,9 902,2
-20 921,3 921,6 921,9
-10 960,6 960,9 961,2
0 999,7 1000,0 1000,3
25 1096,9 1097,3 1097,7
50 1193,4 1194,0 1194,6
100 1384,2 1385,0 1385,8
125 1478,5 1479,4 1480,3
150 1572,0 1573,1 1574,2
CT2S-2 (fumes)
Temp.
°C
Min.
Ω
Nom.
Ω
Max.
Ω
0 999,7 1000,0 1000,3
25 1096,9 1097,3 1097,7
50 1193,4 1194,0 1194,6
100 1384,2 1385,0 1385,8
125 1478,5 1479,4 1480,3
150 1572,0 1573,1 1574,2
5.6 Connecting the optical sensor
Optical sensor asking according to the
diagram with the polarity of the SYG (+) and
GND (-) invitation. Reading the indications
from the optical flame system is in the menu
item:
Information
→
Flame
Incorrect connection of the optical
sensor
will not damage the
regulator or the sensor itself, but
the burner flame detection will be
incorrect.
5.7 Connecting a reserve boiler
The regulator can control the operation of a
reserve boiler (gas or oil). Connection to a
reserve boiler should be made by a qualified
installer, in accordance with the technical
documentation of this boiler. The reserve
boiler should be connected via a relay to
220ºC