Kioti Daedong EX35C, Manual

Page: 143 / 229

5
-26
EX35(C)/EX40(C)/EX45(C)/EX50(C)
(1) Double Acting Valve Lever
(A) Port A (Single Acting)
(B) Port B
H11O528A
EXTERIOR HYDRAULIC CONTROL SYSTEM
DOUBLE ACTING VALVE LEVER
KIOTI supplies two types of the double
acting valves by region: self-return
type and detent type.
For the self-return type double act-
ing lever, it returns to its original po-
sition to block the hydraulic fluid
when it is pushed/pulled and then
released. However, this type of
double acting valve lever should be
pulled or pushed continuously for
operation which is suitable for an
implement with a short operating
time, such as the hydraulic cylinder.
For the detent type double acting
valve lever, it keeps its position af-
ter it is pulled or pushed to a cer-
tain position. Therefore, it is not nec-
essary to hold the lever to a certain
position which is suitable for an
implement with a long operating
time, such as the hydraulic motor.
The implement may shake up
and down as the draft sensor is
under impact when the tractor
is passing over irregular ground
with the middle or lowest top
link hole selected. In this case,
put the draft control lever to the
“Deep” position to decrease the
sensitivity of the draft function
or select the highest top link
hole.
If the tractor has been stored for
a long period of time or the
transmission fluid is just
changed, abnormal noise may
be heard and the hydraulic lift-
ing arm may be inoperable
temporarily. In this case, let the
engine idle for 3 to 4 minutes.
!!!!!
CAUTION