Kioti Daedong EX35C, Manual

Page: 123 / 229

5
-6
EX35(C)/EX40(C)/EX45(C)/EX50(C)
9 . Insert the key into the key switch
and turn it “ON”. Maintain it until
the preheat lamp is turned off
(approx. 8 sec.)
H11O507A
(1) Key Switch ( ) Off
( ) Manual Pre-Heat ( ) Acc
( ) Start ( ) On(Auto Pre-Heat)
7. Set the hand throttle lever into the
neutral position.
8. Depress the clutch pedal(if
equipped).
H11O506A
(1) Hand Throttle Lever
¡ “Increase” “Decrease”
OPERATING PRINCIPLE OF PRE-
HEAT SYSTEM
The glow plug lamp comes on for 8
seconds and then goes off when the
key switch is turned to the “ON”
position.
The engine should be started within 5
seconds after the glow plug lamp goes
off. After the engine is started, post-
heat is performed for 15 seconds with
the key switch in the “ON” position.
he preheat/after-heat function and
glow plug lamp do not operate when
the coolant temperature is 30
86
or higher. In this case, the engine can
be started without the preheat
operation.
WARNING
!!!!!
Never operate the start motor
for 10 consecutive seconds as
it consumes a lot of power.If the
engine cannot be started within
10 seconds, wait for 30 seconds
and try again.
When trying to start the engine
again, make sure that the fly-
wheel is stopped in advance.
(For the manual model, it cannot be
started while the shuttle lever or PTO
is engaged.)