Kingsman Fireplaces MQZCVBG34LPE2, Installation Instructions Manual

Page: 30 / 80

MQZCVBG34 - Front Glass Installation and Removal -
To Install Glass Front:
1. Loosen Upper and Lower Side Glass
Retainer wing nuts until they are only
lightly snug (See A and B at right).
2. Place a bead of High Temp Silicone on
all four corners of the firebox gasket
( see above ). This will seal any gaps
between where the gasket and the
glass corners meet.
3. Install Glass Front into the Lower
Glass Retainer. Install Upper Glass
Retainer. Tighten wing nuts until lightly
snug. Start at the center and work
toward the ends of the glass.
4.
Match Glass Front up with Side Glass
at each end using Alignment Tabs
( See above ).
5.
Tighten wing nuts on Glass Front until
they are snug. Next, fully finger-tighten
wing nuts on Side Glass, and then
back them off 1/4 to 1/2 turn. Finally,
finish tightening all wing nuts on Glass
Front.
NOTE: Do not over tighten nuts as
glass could break.
Wingnuts should be finger-tight on
Glass Front.
To Remove Glass Front:
1. Remove Wing Nuts on the Upper
Glass Retainer and remove the
retainer.
2. Loosen Wing Nuts on the Lower Glass
Retainer but do not remove. Glass
Front can now be lifted out of the
fireplace.
⚠
IMPORTANT: Each corner must
have a dab of high-temp silicone
placed between the ball of the
gasket and the corner glass. This
will fully seal the firebox corners.
SILICONE
Front Glass is placed in front of
corner glass edge.
Upper Glass Retainer
X3
A: Upper Side Glass Retainer
B: Lower Side Glass Retainer
High Temp Silicone on
Firebox Gasket at corner
High Temp Silicone on
Firebox Gasket at corner
SILICONE
ALIGNMENT
TAB
30