Causes
Solutions
No weld output
1. Connected powersupply incorrectly
2. Power switch in off position
1. Connect power supplyaccording to
manufacturer’structions
2. Place power switch in “on”
1. Replace trigger
2. Connect again or replaceif
nec-essary
3. Connect control wire plug again
4. Place Mode switch in correct
pos-ition
1. Increase amperage setting
2. Increase time setting
3. Replace input power cord
4. Change ground clamp location
1. Reduce amperage setting
2. Rrduce weld time
3. Remove coating from material
reduce added pressure
1. Polish kriptol and workpieces
2. Set amperage and time according
to workpiece thickness
1.Checkguncontrol wire and
trigger plug
2.Wait for temperature cool down
1. Trigger damaged
2. Gun control wire broken
3. Control wire plug loosen
4. Mode switch in incorrect position
1. Aamperage too low
2. Weld time too short
3. Input power cord did not meet the
requirement
4. Ground clamp bad contact
1. Output amperage too high
2. Weld time too long
3. Badcontact of electrode tip or
washer with workpiece
1. Kriptol did not polish,workpieces
did not polish
2. ncorrect amperage and time setting
1. Trigger plug loosen
2. Gun control wire broken
3. Over heating
Trigger not working
Piercing workpiece
Kriptol working
unstable
Unit stop working
while operation
Maintenance
Problems
Poor weld
1. Troubleshooting
15
