Remark :
1. Setting amperage too high or time too long can cause workpiece surface damage.
2. Setting correct amperage and time according to the workpiece thickness.
3. Continuing another operation is applicable after these procedures finished.
If not, please shut the power off and switch off the unit.
b. Washer Welding
Set correct time.
Remove welding gunHook
the washer with pull hammer
Slide the hammer to opposited
irection to pull out the dent .
Connect negative outside
wire to a clean ,paint free
location on metal workpiece
as close to welding area
as possible.
Connect washer adaptor with
welding gun and tighten,
Install washer.
Select welding function.
Approximately a 90°angle.
to the dent. Put on pressure
and press trigger.
(Position A orB is recommend)
Set correct power.
10
