Remark :
1. Setting amperage too high or time too long can cause workpiece surface damage.
2. Setting correct amperage and time according to the workpiece thickness.
3. Continuing another operation is applicable after these procedures finished.
If not, please shut the power off and switch off the unit.
Connect negative outside
wire to a clean paint free
location on metal workpiece
as close to welding area
as possible.
Connect carbon rod and
carbon rod adaptor with
welding gun.
d. Carbon Rod Heating
Set correct time.
.
Select welding function.
Turn carbon rod clockwise to heat up
the entire convexity surface.
Cool the surface with a wet
rag or compressed air.
.
(Position A is recommend)
Set correct power
12
