Page 5
4 ANTENNA CONFIGURATION
Antenna configuration is a one time procedure that
MUST BE COMPLETED
before using your
KING Quest antenna. To configure your antenna, do the following:
1. Press
POWER
to turn on the controller. Wait for the lights to stop flashing and for the
COAX
CONNECTION
light to remain on.
2. Press and hold
SCAN
for five seconds. The
COAX CONNECTION
light and the
SCAN
PROGRESS
lights that indicate the currently selected service will begin flashing.
3. Press
SCAN
repeatedly to scroll thru the available service options.
4. When the correct lights turn on to show your desired antenna configuration, press and hold
SCAN
for five seconds to save in memory.
All
SCAN PROGRESS
lights will turn off and the
COAX CONNECTION
light will stop flashing
and remain on.
5. Continue on next page. (If just verifying antenna configuration, turn controller off.)
If you have a DISH receiver
ViP211z
,
ViP211k
,
ViP211
or
411
,
FIRST
choose the
Tailgater Mode
setting
as instructed on these two pages, and then continue with Tailgater Mode (page 14).
To verify the current antenna configuration without changing it, perform steps 1, 2 and 5.
The KING UC1000 Controller is factory preset for
DISH HD and SD
(satellites 110, 119 and 129).
If this is your desired service option, you do not need to configure your antenna. Go to section 6.
If you wish to use a different DISH service option, or if you have DIRECTV or Bell TV service, you will need to
reconfigure the antenna as shown below.
