Page 24
1. Press
POWER
to turn on UC1000 controller. Wait for the lights to stop flashing and for the
COAX
CONNECTION
light to remain on.
2. Simultaneously press and hold
POWER
and
SCAN
for five seconds. Controller begins beeping.
• Single Beep (beep...beep...beep) Alarm is
OFF
.
• Double Beep (beep beep...beep beep) Alarm is
ON
.
3. Press and release
SCAN
to toggle between the on and off conditions.
Beep pattern will change to indicate new condition.
4. When alarm is in desired condition, press and hold
SCAN
for 5 seconds to exit Alarm Mode.
Alarm condition will be saved.
COAX CONNECTION
light will turn solid and
SCAN PROGRESS
lights will stay off.
5. Press
POWER
to turn controller off.
12 ALARM CONFIGURATION: UC1000 CONTROLLER ONLY
This unit is shipped from the factory with the alarm feature in the ON condition. If you wish to have the alarm in the ON
condition, you can skip this section.
When alarm is enabled:
If the coax cable is disconnected from the antenna unit or the controller while the system is
turned on or in standby mode, the controller will sound an audible alarm.
To turn off the alarm when it is sounding, press
POWER
until the controller turns off.
