Page 29
5. Run coax from the antenna unit to the roof edge, then along edge to location where coax will be
fed into the vehicle. If installing an optional second receiver, run second coax to location where it
will enter the vehicle. Secure (both) coax to roof every 12-18 inches (see below).
6. Drill 3/4” hole through the roof and into the cabinet where receiver is stored. Feed coax down
through hole. Seal opening with roof compatible sealant so that it is completely waterproof
(inside and outside of the 3/4” hole). Repeat for second coax if present.
7. Fasten cable entry cover to roof with appropriate adhesive sealant and roof fasteners. Seal
mounting holes, perimeter of cover and cable opening so they are completely waterproof.
IMPORTANT!
Roof hole(s) for wiring must be sealed
so they are completely waterproof.
Sealant must be roof compatible.
Use adhesive sealant compatible with roof material. Installer is responsible for determining proper roof
compatible adhesive sealant and fasteners for cable entry cover.
Roof holes for cables must be sealed so they are completely waterproof. Mounting holes, perimeter of cable
entry cover and cable opening of cable entry cover must be sealed so they are completely waterproof.
8. Remove blue protective sheet from the antenna unit.
9. Go to next page for internal wiring.
