Page 11
SCAN FOR SATELLITES
1. Press and hold
SCAN
for 3 seconds.
•
The antenna will scan for the selected satellites. The four
SCAN PROGRESS
lights will cycle
on and off to indicate a scan is in progress.
•
As satellites are located, the corresponding
SCAN PROGRESS
lights will turn on (see below).
•
When scan is complete, the appropriate lights will turn on to show which satellites were found.
•
Wait for the program guide to download and then select your desired channel.
If you move the vehicle, you will have to reacquire the satellites by repeating the scan process. The KING Quest will
go into “sleep mode” after 15 minutes and the
COAX
CONNECTION
light will dim.
To turn the unit off at any time, press
POWER
for 3 seconds.
DISH AND BELL TV SUBSCRIBERS:
If you are using a second receiver, see SECOND RECEIVER OPERATION:
DISH AND BELL TV on page 12.
Use this chart to determine which satellites have been found.
NOTE:
The order of the lights corresponds to the order of the satellites listed.
Example for
DISH SD
: The 110 satellite corresponds to Light 1, and the 119
satellite corresponds to light 2.
