Page 28
3. Mount the antenna unit using the
(4) mounting holes. Make sure to
seal mounting holes with roof
compatible sealant.
4. Connect one end of a coax cable (sold separately) to the MAIN port and tighten connection
(see below).
DO NOT OVER TIGHTEN
.
If using a second receiver, connect end of a second coax (sold separately) to the AUX port.
Tighten connection.
DO NOT OVER TIGHTEN.
The installer is responsible for weatherproofing all holes with sealant.
The installer is responsible for determining the most appropriate fastener to secure the antenna unit to the roof.
Depending on the roof material, fasteners such as lag screws, well nuts, sheet metal screws, toggle bolts and T
anchors may be used, and should always be used in combination with a roof compatible sealant.
If rubber feet have been installed on the bottom of the antenna unit, lay the unit on a soft non-scratching
surface and remove them. If rubber feet came packaged with the unit, do not apply them.
There are two coax ports on the back of the antenna unit. The one labeled “MAIN”
MUST
be connected to the main
receiver in vehicle. The one labeled “AUX” can be used for an additional receiver if desired.
IMPORTANT!
Coax connections should be snug.
DO NOT OVER TIGHTEN!
