18
01 as decrement mode
，
press up or down button to change it
，（
System defaults as 00
），
Press
the OK button within 3sec or 3sec does not press the button; The system confirms the
completion of the setting and makes a beep.
※
Note: If the setting count status is not displayed after setting, press the OK key to
switch.
3.3 In the standby or working state, press SET button 3 times to enter the system of
Beep
setting
，
LED flashes and display as
，
00 as turn on the beep,
，
01 as turn
off the beep function
，
press UP or Down button to change it,
（
system defaults as 00
），
Press
the OK button within 3sec or 3sec does not press the button; The system confirms the
completion of the setting and makes a beep.
3.4 In the standby or working state, press SET button 4 times to enter the system of Vibration
delay setting
，
LED flashes and display as
，
press UP or Down button to
change the time of vibration delay setting
（
system defaults time of vibration delay time is based
on the property of screw type, setting range as 01~12Sec,
）
，
Press the OK button within 3sec or
3sec does not press the button; The system confirms the completion of the setting and makes a
beep.
3.5 In the standby or working state, press SET button 5 times to enter the system of Vibration
intensity setting
，
LED flashes and display as
，
press UP or Down button to
change the setting of vibration intensity
（
system defaults time of vibration intensity is based on
the property of screw type, setting range as 01~10, 5V~10V, 10 steps in total, every 0.5V as 1
step
），
Press the OK button within 3sec or 3sec does not press the button; The system confirms
the completion of the setting and makes a beep.
3.6 In the standby or working state, press SET button 6 times to enter the system of roller
