PCR-LE2 series
11
Connecting the Load
Connecting cables to the PCR6000LE2 or PCR9000LE2
Single-phase output
1
Check that the POWER switch is turned off.
2
Check that the breaker of the switchboard is off.
3
Pull out the terminal block tray.
4
Securely connect the load cables to the OUTPUT
1P2W terminal block.
If the load has a ground (GND) terminal, be sure to connect it
to the G terminal of the PCR-LE2 Series OUTPUT 1P2W termi-
nal block. Be sure to use a wire whose diameter is greater than
or equal to the diameter of the wires used to connect the load.
G N
L
M8
OUTPUT 1P2W terminal block
5
Return the terminal block tray to its previous position.
If you do not insert the terminal block tray all the way into
its storage compartment, an electric current will not flow
through the PCR-LE2 Series even if the POWER switch is
turned on.
Single-phase three-wire output or three-phase out-
put
1
Check that the POWER switch is turned off.
2
Check that the breaker of the switchboard is off.
3
Pull out the terminal block tray.
4
Securely connect the load cables to the OUTPUT
3P4W(1P3W) terminal block.
If the load has a ground (GND) terminal, be sure to connect it
to the G terminal of the PCR-LE2 Series OUTPUT 3P4W(1P3W)
terminal block. Be sure to use a wire whose diameter is greater
than or equal to the diameter of the wires used to connect the
load.
G
N
U
V
G
N
U
V
W
M5
M5
Single-phase,
three-wire output
Three-phase
output
OUTPUT 3P4W(1P3W) terminal block
5
Return the terminal block tray to its previous position.
If you do not insert the terminal block tray all the way into
its storage compartment, an electric current will not flow
through the PCR-LE2 Series even if the POWER switch is
turned on.
