Kikusui DME1600, Manual

Page: 16 / 56

16
DME1600
CONFigure Commands
The CONFigure commands are slightly more flexible than the MEASure? commands. These
commands set the parameters, range, and resolution for the specified feature, but they do not
start measurement. To start measurement, use the INITiate or READ? command.
CONF:VOLT:DC
Sets the measurement function to DC voltage measurement and sets the range and resolu-
tion. This command does not start measurement.
Command
CONFigure:VOLTage:DC
{<range>|MIN|MAX|DEF},{<resolution>|MIN|MAX|DEF}
CONF:VOLT:DC:RAT
Sets the measurement function to DC:DC ratio measurement and sets the range and resolu-
tion. This command does not start measurement. In ratio measurement, the specified range
is applied to the input signal, but the auto range is determined by the reference signal.
Command
CONFigure:VOLTage:DC:RATio
{<range>|MIN|MAX|DEF},{<resolution>|MIN|MAX|DEF}
CONF:VOLT:AC
Sets the measurement function to AC voltage measurement and sets the range and resolu-
tion. This command does not start measurement. In AC measurement, the default resolution
is 5 1/2 digits. Therefore, only the front panel display is affected by the specified resolution
parameter.
Command
CONFigure:VOLTage:AC
{<range>|MIN|MAX|DEF},{<resolution>|MIN|MAX|DEF}
CONF:CURR:DC
Sets the measurement function to DC current measurement and sets the range and resolu-
tion. This command does not start measurement.
Command
CONFigure:CURRent:DC
{<range>|MIN|MAX|DEF},{<resolution>|MIN|MAX|DEF}
CONF:CURR:AC
Sets the measurement function to AC current measurement and sets the range and resolu-
tion. This command does not start measurement. In AC measurement, the default resolution
is 5 1/2 digits. Therefore, only the front panel display is affected by the specified resolution
parameter.
Command
CONFigure:CURRent:AC
{<range>|MIN|MAX|DEF},{<resolution>|MIN|MAX|DEF}
CONF:RES
Sets the measurement function to 2-wire resistance measurement and sets the range and
resolution. This command does not start measurement.