B140G Bellows Drive Opera on
Be sure the ON/OFF Valve is in the "OFF" posi on (lever down). Engage the drive system by (pulling up & over) dropping the
Holdout Handle fully down. Turn on the water. Confirm the sprinkler is opera ng as expected and in the desired arc. A er all air
is purged from the system and the sprinkler is opera ng smoothly, turn the ON/OFF Valve to the "ON" posi on (lever up). Set
the Speed Control Valve to the desired retrac on speed.
The Speed Control Valve, located on the valve assembly, regulates the speed at which water can fill the Bellows.
Note: The Water- Reel requires 45 Pounds Per Square Inch (PSI) and adequate water flow capacity (GPM) to operate properly.
Consult your Kifco dealer if you do not have an adequate water supply.
Observe water pressure, travel speed, and sprinkler performance to confirm desired performance. See pages 20 or 21 for
performance charts.
When the Gun Cart completes the irriga on run and has contacted the Shut Off Bar, the retrac on of the tube will stop.
With the irriga on run completed, turn off water supply. Relieve pressure first by opening the Drain and disconnect the
Supply Hose. Remove and store the Bellows Exhaust Drain Hose.
Li & latch the Gun Cart into its transport posi on. Pull the Water-Reel forward to relieve pressure on the Stabilizer Legs.
Li & latch both Stabilizer Legs into transport posi on.
The Water-Reel is now ready to be moved and set up in a new loca on.
Note: Some municipali es prohibit the use of water mains intended for fire protec on and there may also be requirements
for back-flow preven on. Inves gate and obey all local regula ons regarding the use of water.
On/Off Valve
Drain
Speed Control Valve
On
Off
Holdout Handle
Supply Hose
Important
Open Drain to relieve pressure on Supply Hose
a er turning off water supply
