Kielder KWT-011, Original Instruction Manual, Page: 12 / 20

12
KWT-011-IMA21 Kielder WT Ltd
Setting The Torque or Application
Engage the desired torque setting by aligning
the corresponding number on the torque ring
(L) with the indicator arrow in the centre of the
tool body (K).
Drill Applications
Always allow the tool to do the work. When
drilling; applying excess pressure to the
rear of the tool may actually slow down
the drilling process. By only applying a
modest amount of rear pressure to the tool,
all internal components can operate freely
and the hammer motion is more efffectively
transferred through the drill bit, thus speeding
up how quickly a hole is drilled.
Speed Selection
Slide the gear selection switch to choose
a low (M) or high speed (N) to suit the work
being undertaken. It is possible to fine tune
either of the speed settings via the variable
speed trigger, the more the trigger is
depressed, the higher the speed.
When selecting a different speed it maybe
necessary to run the motor slowly, by
partially depressing the trigger for the gears
to properly align. Once the motor is slowly
running apply pressure to the speed selector
switch and the gear will engage.
CAUTION!
Check the gear selector switch
before use. Use at low speed
when high torque is required.
(Using at high speed when high torque is
needed may cause the motor to stall).
Do not operate the gear selector switch while
the tool is running at full power. This may cause
permanent damage to the tool and / or battery.
(M)
(N)
(L)
(K)
Symbol Function
Drill Mode
Use for drilling applications in
materials such as wood metal,
or plastic.
1-18
Screw-Driving Mode
Adjust torque ring (L) to one
of the 18 settings to limit
the torque according to the
fastening kind and/or material
being screwed into.
1 is the lowest, 18 is the
highest.
NOTE: If Drill Mode is selected then the
torque limiting clutch is ‘locked’ and full
torque will be imparted.