Kielder KWT-011, Original Instruction Manual, Page: 10 / 20

10
KWT-011-IMA21 Kielder WT Ltd
USAGE
Fitting or Removing the Bit
This tool is equipped with a keyless drill
chuck.
Attaching a Drill or Driver Bit
Insert the bit (A) into the centre of the 3 Jaws
(B) in the chuck and turn the lock collar (C)
clockwise (looking from the front), tighten
firmly until the bit is fully secured by the
jaws.
To optimise the grip from the chuck; the bit
should be inserted well inside so the full length
of the chuck jaws grip the shank (D), but
without the end of the drill bit resting against
chuck retaining screw (E).
Note: If excessive
play occurs in the
chuck, secure the
drill in place and open
the chuck jaws and
tighten the screw (E)
with a screwdriver
by turning it
anticlockwise (looking
from the front).
Removing a Drill or Driver Bit
Turn the lock collar (C) anticlockwise (looking
from the front) then remove the bit (A).
Attaching or Removing the
Battery Pack
Connect The Battery Pack:
Line up the alignment channels and slide on
the battery pack.
Slide the battery pack until it locks into
position with an audible “CLICK”.
Remove The Battery Pack:
Depress the button (F) at the front of the
battery indication panel and slide the
battery pack out.
CAUTION!
When fitting or removing a bit,
place the switch to the centre
position (switch lock) or disconnect the
battery pack from the tool.
(A)
(A)
(B)
(C)
(C)
(D)
(E)
(F)
(E)