A
Page 11 / 26
Datasheet 2.50-40.051-71-EN
SBM51/06
Product Description
DDC Software Menu M090 (SBM51 gateway)
The DDC software menu, M090 SBM51 gateway (previously gateway menu), can be set to the
SBM51/06 basic program up to 32 times. Two gateway menus with addresses 1 and 2, 3 and 4, etc.
and the menu with address 32 are automatically created per FI. A maximum of 17 M090 menus are
therefore required for a maximum of eight FIs that can be connected.
The parameter lists for the DDC software menu M090 are described in section “Parameter Lists for
the DDC Software Menus M090 and CD_SB51 (SBM51 Gateway)” from page 12.
Parameter List in the DDC4000 System
SY_SBM51 “System SBM51” System Object
The SY_SBM51 “System SBM51” system object contains parameters that represent the special
characteristics of an SBM51/06 as a gateway module:
Cycle Parameter: "Readout cycle"
The parameter cycle readout cycle is not needed for SBM51/06.
Enable parameter: “Enable bus”
The Enable parameter turns the communication for the bus system (FC bus) on or off:
■
“0”
→
FC bus OFF
■
“1”
→
FC bus ON.
Hardware Object H000 “Device on Bus”
When creating an SBM51/06 in the DDC4000 central unit, 32 H000 hardware objects “Device on bus”
are automatically created under /b1/00. Of those, only the following 17 hardware objects are used:
01 to 16 and 32.
Each H000 hardware object contains the
Active
and
Config
parameters that represent the special
characteristics of a frequency inverter on the bus.
Active Parameter
The parameter
Active
shows if the FI was registered on the bus.
■
“1”
→
FI is registered on the bus.
■
“0”
→
FI is not registered on the bus.
Parameter Config
Create the gateway menu CD_SB51 “SBM51 Menu” via Parameter Config.
Parameter Plain text
Setpoint /
value
Type
Cycle
Readout cycle
Setpoint
Binary
value
Enable
Bus enable
Setpoint
Binary
value
Parameter
Plain text
Setpoint /
value
Type
Active Pin
active
Value
Binary
value
Config
Configuration
Setpoint
Binary value
